• Maximum speaker cable lengths

    Maximum speaker cable lengths for :


    • Low impedance (2, 4, 8 and 16 ohm)
      • Quality
      • 3 dB loss, which could be an alternative to a line transformer system

    • High impedance (systems with line transformer)
      • 70V
      • 100V




    Low Impedance


    Results are for a total damping factor of 25, using an amplifier with a damping factor of 400 and signa loss of 0.3 dB. 25 is the minimum damping factor for a "quality installation". For higher quality, specially for bass, the above recommended lengths would be halved



    Results are for a signal loss of 3 dB and are in practice independent of the amplifier damping factor


    Alta Impedancia (High Impedance)


    Results are for a signal loss of 1 dB. For 3 dB loss, multiply the maximum lengths by 3.5



    Results are for a signal loss of 1 dB. For 3 dB loss, multiply the maximum lengths by 3.5


    NOTE: A comma is used as decimal separator instead of a colon. Multiply the resistance/100 m value by 0.3048 to get a value for resistance/100 feet. Multiply meter lengths by 0.3048 to get lengths in feet.


  • Ad

  • News

    QSC expands Q-SYS Control plugin library with Cisco and Barco meeting room endpoints



    QSC has announced this week the availability of two new Q-SYS™ Control plugins, enabling quick integration and a consistent user experience for the Cisco conferencing... Read more

    DirectOut PRODIGY Series Now Available With Ember+ Network-Based Protocol

    DirectOut's PRODIGY Series of DSP processors was designed to add support of third party control protocols, easing integration into projects where independent or existing... Read more

    PreSonus AVB-D16 brings Dante to StudioLive Series III

    The first plug-and-play endpoint that bridges AVB and Dante networks, the PreSonus AVB-D16 16x16 AVB-to-Dante Bridge enables sending and receiving up to 16 audio channels... Read more

    Waves Audio now shipping the WSG-HY128 Card for Yamaha RIVAGE PM Series

    Waves Audio WSG-HY128 Card for Yamaha RIVAGE PM Series Consoles is now shipping.

    The Waves WSG-HY128 is a card for HY slots that makes it possible to run Waves plugins... Read more
  • Recent articles

    Y-cables, looping audio signals through

    This article will explain loop-though connections and "y-cables" for analog audio signals.

    To obtain one or more copies of a signal (for example, to distribute the signal from a mixer to various self-powered speakers or power amplifiers) we use parallel connections. To do this we simply connect each terminal (pin) of the connectors in parallel. That is, 1 to 1, 2 to 2 and 3 to 3 (or tip to tip, ring to ring and sleeve to sleeve in a TRS connector). When we split a signal in two in this way, we refer to a "Y-cable" or "Y" connection, since the division of a signal in two looks like letter "y". Contrary to what it may seem, a y-cable is not a technically incorrect solution, but a correct way of splitting the audio signal. In fact, when a self-powered loudspeaker system or one channel of... Read more

    Pinouts

    Pin asignments for an assortment of connectors: XLR, 1/4" (jack), 1/8" (minijack), SpeakON, DB25, DMX ...


    ... Read more

    Octaves and third-octaves

    Octaves, thirds of octaves and decades are divisions of the spectrum used in audio, since they work in the same way as the ear, increasing their width in Hertz as frequency increases, and decreasing it when frequency decreases. They are used for the definition of the width of filters, as well as for the spectral analysis.... Read more
  • PAcalculate app