Dynacord has announced the introduction V600:2, a new member of its V Series family of commercial amplifiers. With a total output capacity of 600 watts, this compact two-channel amplifier is designed for small to mid-sized fixed installations including educational facilities, hospitality venues, retail areas and houses of worship.
It boasts the same features and Dynacord technologies on board as the four-channel model V600:4, such as powerTANK technology, adding flexible power allocation, acting as a power reservoir. With direct access to the total power of 600 watts, the V600:2 can deliver asymmetric power across all channels as needed. Dynacord’s patented VLD (Variable Load Drive) technology reportedly allows the amplifier channels to be driven at 4 ohms, 8 ohms, 70 V or 100 V without affecting output power.
Overall power consumption is said to be reduced with ecoRAIL. APD (Auto Power Down) automatically powers down the amplifier when no audio signal is present.
Inputs and outputs use EuroBlock connectors. DIP switches on the rear panel adjust for the load (100V, 70V, 4 or 8 ohm) the high-pass (100 or 150 Hz) and low-pass (150 Hz) behaviour. To link the channels from one unit to another, an RJ45 connector is used to parallel all signals. Volumen controls are also located on the rear panel.
A single rack unit high and half a rack width wide, the included brackets facilitate single or dual rack-mount options as well as installation under counters. Two amplifiers fit in a single rack unit when rack-mounted side by side.
The V600:2 is said to combine best-in-class features at a very attractive price. It will be available in spring 2024. It is also sold under the Bosch brand name as model SYNSONA PRM-2P600.